Replacing the Payter module - PEM-0962

Tools required

• 7mm spanner

• Large Phillips screwdriver

• Small Phillips screwdriver

Open

Parts needed

• Payter terminal PEM-0962

• SIM card (from the previous Payter module)

• SAM card (from the previous Payter module)

Open

Payter PEM-0962

https://vimeo.com/856691652

Disconnect the LTE antenna and the power supply.

Unscrew the four wing using the 7mm spanner.

Remove the Payter module from the casing and remove the protecting rubber.

Remove the three screws and open the two covers to access the SIM and SAM cards.

Remove the SIM and SAM (CCA module and HSH module) cards, place them into the new Payter module and lock the in place, by pushing the mechanism towards the narrower part of the cards.

Return the protective covers back in place and screw in the three screws, as seen in the picture above.

Return the protective rubber.

Return the Payter into the casing and screw back the nuts.